Page Index Toggle Pages: 1 Print
Normal Topic Distributor Bushings replacement (Read 344 times)
Project Jeep

Still Plays With Jeeps

Posts: 12
Joined: 08/08/17
Distributor Bushings replacement
05/12/19 at 15:37:20
Print Post  
What method has proven acceptable for removing worn distributor shaft bushings and installing new ones? The service manual just says to replace them if worn but without any clue as to how to get them out and in. Any 'been there,done that' suggestions will be appreciated. Distributor is the standard AutoLite IAD-4008A. Thank you
Back to top
IP Logged
Flatfender Enthusiast

Plays With Jeeps

Posts: 173
Location: East Tennessee
Joined: 03/20/17
Gender: Male
Re: Distributor Bushings replacement
Reply #1 - 05/13/19 at 20:48:42
Print Post  
The tool needed is a bushing driver. It will safely drive out and re install the new ones.

People think I go out of my way to piss them off.
Trust me, It's not out of my way at all.
Back to top
IP Logged
Page Index Toggle Pages: 1
Bookmarks: Facebook Google Google+ Linked in Twitter Yahoo